Hoosier Waterjet

a division of High Performance Alloys, Inc.

Custom abrasive waterjet cutting

Abrasive water jet

Hoosier WaterJet offers toll abrasive waterjet cutting. Abrasive waterjet cutting as a service!

Abrasive water jet cutting

Abrasive water jet cutting, toll cutting, abrasive waterjet of rubber, metals, and plastics for the industrial, commercial and hobby sectors.

Abrasive waterjet

The waterjet stream of water from a 60KSI pump comes out at MACH 3 ( three times the speed of sound )! It is recommended to wear hearing protection when working around these machines. Eye protection is a must, as the water and garnet go everywhere in the shop. Water can shoot 5 feet from the table, carrying garnet and other material particulate. From there the dust can be blown or tracked into many other areas of the building.

Learn more about the process and applications.

Abrasive Water Jet Cutting Capability:

Cut almost any material

From metals like steel, aluminum and tungsten carbide; to glass, stone, tile and even plastics, rubber and vinyls.

Wide range of thicknesses cut

From as thin as 0.018 inch to 4 inches, and even thicker material cuts are possible.

Cutting table is 6.5 feet x 13 feet

Pieces can be cut from sheets or plates as large as the table. Larger format allows for nesting of parts to achieve the best yields possible.

Cutting tolerances

Close tolerances, of plus or minus 5 thousandths of an inch (+/- 0.005"), are possible over the entire length of the part.

Customizable cutting

We allow input during the quoting phase to ensure that the part is not over specified. By allowing the customer to select multiple tolerances, or edge finishes on the part in various areas.

First Article Parts

By using our First Article cutting option, you can make sure that the part meets all the requirements before production cutting begins.